Hunter Ceiling Fan Replacement Capacitor: A Comprehensive Guide
Hunter ceiling fans are known for their quality and performance, but like any mechanical device, they can experience issues over time. One common problem is a faulty capacitor. Replacing a capacitor in a Hunter ceiling fan is a relatively simple task that can be completed in a few minutes with the right tools and a bit of know-how. This guide will walk you through the steps of replacing a Hunter ceiling fan capacitor.
Step 1: Gather the Necessary Tools and Materials
Before you begin, gather the following tools and materials:
- New Hunter ceiling fan capacitor (the correct type and size for your fan)
- Phillips head screwdriver
- Flat head screwdriver
- Wire stripper
- Electrical tape
- Safety glasses
Step 2: Turn Off the Power
To ensure your safety, turn off the power to the ceiling fan circuit at the circuit breaker panel before you begin working on the fan.
Step 3: Remove the Fan Cover
Locate the screws that hold the fan cover in place and remove them using the Phillips head screwdriver. Carefully remove the fan cover and set it aside in a safe place.
Step 4: Locate the Capacitor
The capacitor is usually located inside the fan housing, near the motor. It is a small, cylindrical-shaped component with two wires attached to it. The capacitor may be covered by a plastic or metal housing, which you will need to remove to access the capacitor.
Step 5: Disconnect the Capacitor
Use the flat head screwdriver to pry open the wire connectors on the capacitor. Be careful not to damage the wires. Once the wires are disconnected, remove the capacitor from the fan housing.
Step 6: Connect the New Capacitor
Take the new capacitor and connect the wires to the corresponding terminals on the fan motor. Make sure to connect the positive (+) wire to the positive terminal and the negative (-) wire to the negative terminal. Twist the wire connectors together until they are secure.
Step 7: Secure the Capacitor
Once the capacitor is connected, secure it in place using the mounting screws. Make sure the capacitor is firmly attached to the fan housing.
Step 8: Reinstall the Fan Cover
Reinstall the fan cover and secure it with the screws you removed earlier. Make sure the fan cover is properly aligned and seated.
Step 9: Turn On the Power
Restore power to the ceiling fan circuit at the circuit breaker panel. Turn on the fan and check that it is running smoothly and quietly.
Replacing a capacitor in a Hunter ceiling fan is a simple task that can be completed in a few minutes. By following these steps, you can ensure that your fan is running properly and safely.
Hunter Ceiling Fan Control Wire Harness Repairs Start Sd Capacitors Reverse Switches 240 V Genuine Parts
Hunter 23855 Ceiling Fan How To Get Capacitor Doityourself Com Community Forums
Hunter 23855 Ceiling Fan How To Get Capacitor Doityourself Com Community Forums
Cbb61 5uf 4 Wire Capacitor Hunter Ceiling Fan Genuine Replacement
Triple Capacitor G016906000 Oem Hunter Ereplacementparts Com
Top 6 Technical Faults With A Hunter Ceiling Fan
Hunter Ceiling Fan Wiring Harness Switches Parts Cap Model 51027
Capacitors Ceiling Fans
How To Replace A Capacitor In Ceiling Fan 3 Ways
Hunter Ceiling Fan Wiring Harness Switches Parts Cap Yce Model 23509